You can manipulate, delete, and display adaption registers by marking cells for adaption. Since these registers are used to adapt the grid, the ability to manipulate them provides additional control over the adaption process.
Management of adaption registers is performed in the Manage Adaption Registers panel (Figure 26.11.4). You can also open this panel by clicking on the Manage... button in any of the adaption panels.
You can modify and manipulate adaption registers by:
Changing Register Types
If the adaption register is converted to a mask, the cells marked for refinement are ACTIVE, and all other cells are INACTIVE (i.e., the cells marked for coarsening are ignored). Generally, the adaption registers converted to masks are those that are generated by adaption functions that mark cells exclusively for refinement, such as region or isovalue adaption functions. The other major difference between adaption and mask registers is the manner in which they are combined.
To change the type of one or more registers from adaption to mask, or vice versa, do the following:
The new type of the register (if multiple registers are selected, the most recently selected or deselected register) will be shown as the Type under Register Info. Select each register individually to see what its current type is.
After the individual adaption registers have been created and appropriately modified, they are combined to create hybrid adaption functions.
For example, creating an adaption function based on pressure gradient may generate cells marked for refinement and coarsening throughout the entire solution domain. If this register is then combined with a mask register created from cells marked inside a sphere, only the cells inside the sphere will be marked for refinement or coarsening in the new register.
For example, consider two adjacent, circular masks. Applying one mask to the adaption register and then applying the other mask to the result of the first combination would give a much different result than applying the combination of the two masks to the initial adaption register. The second combination results in a greater possible number of marked cells.
To combine two or more registers, do the following:
The selected registers will remain intact, and the register(s) resulting from the combination will be added to the Registers list. In some instances, three new registers may be created:
For more information about combining registers, see Section 26.11.
The primary reason for deleting registers is to discard unwanted adaption registers. This will reduce confusion and the possibility of generating undesired results by selecting these discarded registers. In addition, only 32 adaption registers can exist at one time. Therefore discard unwanted registers to make room for new ones. You can delete any number of adaption registers.
To permanently remove one or more registers, do the following: